Fastener Tightening Specifications: Refer to Fastener Tightening Specifications.

Preliminary Procedures

1. Open the rear compartment lid.
2. Remove the lower applique from the rear compartment lid by pulling one edge upward and then working across to the opposite side releasing the integral spring clips from the rear compartment panel.

1

Gasket, Foam (Qty: 6)

Tip
Ensure the foam gaskets are in place prior to installing the rear applique.

2

Clips, Spring (Qty: 6)

3

Applique Assembly, Rear Compartment Lid Lower

Tip

1. Upon installation of the new lower applique, position the center alignment pin to the hole at the center of the rear compartment lid.
2. Working from the center alignment pin outward to both sides, secure the lower applique to the rear compartment lid.