Tools Required
| • | J 25022
End Play Fixture
Adapter (245 mm and 258 mm) |
| • | J 34725
End Play Checking
Adapter (298 mm) |
| • | J 43205
End
Play Fixture Adapter (300 mm) |
Important: Torque converter size is model dependent.
- Install an end play fixture adapter.
| • | Use
J 25022
for a 245 mm
and 258 mm turbine shaft (1). |
| • | Use
J 34725
for a
298 mm turbine shaft (2). |
| • | Use
J 43205
for a
300 mm turbine shaft (3). |
- Install the
J 24773-A
.
- Remove an oil pump retaining bolt.
- Install
J 25025-7A
(or
a 278 mm or 11 in bolt) and lock nut.
- Install
J 8001-3
.
- Set the
J 8001-3
to zero.
- Pull up on
J 24773-A
.
Proper end play should be 0.13-0.92 mm (0.005-0.036 in).
- The selective thrust washer (616), which controls the end play,
is located between the input housing (621) and the thrust bearing (615) on
the oil pump hub.
If the end play measurement is incorrect, refer to
Torque Converter End Play Specifications
. Choose a new
selective thrust washer (616) based on the original selective washer and the
information contained in the table.
If the dial indicator shows no end play, the selective thrust washer (616)
and thrust bearing (615) may have been misassembled.
- Correct the end play by changing the selective thrust washer (616).
