Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Remove the left-side portion of the cowl vent grille. Refer to
Air Inlet Grille Panel Replacement
in Body Front End.
- Remove the nut and the washer that secure the wiper arm linkage to the
motor drive shaft.
- Pry the wiper arm linkage off the motor drive shaft.
- Remove the nuts.
- Disconnect the electrical connector.
- Remove the bolts and the wiper motor.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the wiper motor with the bolts.
Tighten
Tighten the wiper motor bolts to 8 N·m
(71 lb in).
- Connect the electrical connector.
- Press the wiper arm linkage onto the motor driveshaft.
- Install the wiper arm linkage to the motor driveshaft with the washer
and the nut.
Tighten
Tighten the wiper arm linkage nut to 5 N·m
(44 lb in).
- Install the left side portion of the cowl vent grille. Refer to
Air Inlet Grille Panel Replacement
in Body Front End.
- Connect the negative battery cable.