GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Optra 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Manifold Absolute Pressure Sensor Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1701074 Size: SH
  1. Disconnect the negative battery cable.
  2. Disconnect the fuel rail. Refer to Fuel Injection Fuel Rail Assembly Replacement .
  3. Disconnect the manifold absolute pressure (MAP) sensor connector from the MAP sensor.
  4. Remove the MAP sensor retaining bolt.
  5. Remove the MAP sensor from the intake manifold.

Installation Procedure

    Object Number: 1701074 Size: SH
  1. Connect the MAP sensor connector to the MAP sensor.
  2. Install the MAP sensor into the intake manifold.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the MAP sensor retaining bolt.

    4. Tighten
    Tighten the MAP sensor retaining bolt to 8 N·m (71 lb in).

  4. Connect the fuel rail. Refer to Fuel Injection Fuel Rail Assembly Replacement .
  5. Connect the negative battery cable.