Schematic References: Starting and Charging Schematics

Connector End View References: Component Connector End Views

1

Did you review the following description and operations and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Engine Electrical

Turn ON the ignition, with the engine OFF.

Does the battery charge indicator illuminate?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Disconnect the generator connector.
2. Connect a 20 amp fused jumper to the charge indicator control circuit.
3. Turn the ignition switch to the ON position.

Does the battery charge indicator illuminate?

Go to Step 4

Go to Step 6

Test the generator supply voltage circuit for an open. Refer to Circuit Testing or Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 5

Replace the generator. Refer to Generator Replacement .

Did you complete the replacement?

Go to Step 9

--

1. Inspect the charge indicator bulb and replace as necessary.
2. Test the charge indicator supply voltage circuit for an open. Refer to Circuit Testing or Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 7

Test the charge indicator control circuit for an open. Refer to Circuit Testing or Wiring Repairs .

Did you complete the replacement?

Go to Step 9

Go to Step 8

Repair or replace the instrument panel cluster (IPC). Refer to Instrument Cluster Replacement .

Did you complete the repair or replacement?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2