GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Optra 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Steering Wheel Position Sensor Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

    2. Object Number: 1975334 Size: SH
  2. Disconnect the steering wheel position sensor electrical connector (1) on the steering column.
  3. Remove the steering column from the vehicle. Refer to Steering Column Replacement .

    4. Object Number: 1975337 Size: SH
  4. Remove the screw (2) from the steering wheel position sensor (1).
  5. Remove the steering wheel position sensor by pulling the sensor downward from the steering column shaft.

Installation Procedure

    Object Number: 1975337 Size: SH
  1. Install the steering wheel position sensor (1) to the steering column shaft.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the screw (2) to the steering wheel position sensor.

    3. Tighten
    Tighten the steering wheel position sensor screw to 2 N·m (18 lb in).

  3. Install the steering column to the vehicle. Refer to Steering Column Replacement .

    4. Object Number: 1975334 Size: SH
  4. Connect the electrical connector (1).
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .