Circuit Description
When the ignition switch is turned to ON, the sensing and diagnostic module (SDM) will perform a turn-on test to diagnose critical malfunctions within the SDM itself.
Upon passing this test, ignition and deployment loop voltages are measured to ensure that they are within their normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deploy loops.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC 023 Battery Voltage High
Conditions for Running the DTC
Ignition voltage is within the normal operating voltage range.
Conditions for Setting the DTC
The voltage supplied from the battery is over 16.5 volts.
Action Taken When the DTC Sets
The SDM commands the AIR BAG indicator ON.
Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Step | Action | Yes | No |
|---|---|---|---|
|
Caution: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Caution in the Preface section. Caution: Refer to Sensing and Diagnostic Module Handling Caution in the Preface section. Schematic Reference: Component Connector End Views Connector End View Reference: Component Connector End Views | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Inspect the vehicle charging system. Refer to Charging System Test . Is the charging system OK? | Go to Step 4 | Go to Step 3 |
3 | Repair the charging system. Did you complete the repair? | Go to Step 5 | -- |
4 |
Did you complete the repair? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
