For 1990-2009 cars only
- Apply automatic transmission fluid to the new forward clutch accumulator piston fluid seal ring (613).
- Install the new forward clutch accumulator piston fluid seal ring (613) onto forward clutch accumulator piston (612).
- Install the forward clutch accumulator piston spring (614) and the forward clutch accumulator piston (612) into the forward clutch accumulator cover (616).
- Apply automatic transmission fluid to the new forward clutch accumulator cover seal (615).
- Install the new forward clutch accumulator cover seal (615) onto forward clutch accumulator cover (616).
- Install the forward clutch accumulator cover assembly onto the transmission case cover.
- Install one of the two forward clutch accumulator cover bolts (617) and tighten to 10 N·m (89 lb in).
- Apply automatic transmission fluid to the 3 new forward clutch housing fluid seal rings (607).
- Install the forward/direct clutch housing thrust selective bearing race (628) without any markings. This is the 0.81 mm (0.032 in) thick race and will determine the correct thickness for the forward/direct clutch end play measurement.
- Apply automatic transmission fluid to the 2 new 4-5 clutch apply pipe seals (608).
- Install the 2 pipe seals (608) onto the 4-5 clutch apply pipe (609).
- Using a plastic hammer if needed, install the 4-5 clutch apply pipe (609) into the transmission case cover.
- Install the two, 4-5 clutch apply pipe retainers (610).
- Install the four, 4-5 clutch apply pipe bolts (611) and tighten to 7 N·m (62 lb in).
Caution: Refer to Fastener Caution in the Preface section.
Install the 3 new forward clutch housing fluid seal rings (607).
Note: Do not damage the pipe seals or the 4-5 clutch apply pipe.
