For 1990-2009 cars only
- Install the speedometer-driven gear into the transaxle housing using the speedometer-driven gear bolt and tighten to 5 N·m (44 lb in).
- Install the clutch-release bearing guide and the clutch-release bearing. Refer to Clutch Concentric Actuator Cylinder Replacement.
- Install the backup lamp switch into the transaxle housing and tighten to 20 N·m (15 lb ft).
- Install the differential into the transaxle housing. Refer to Differential Case Assemble.
- Install the bearing plate, with the shafts attached.
- Install the bearing plate bolts and tighten to 22 N·m (16 lb ft).
- Install the transaxle cover using the transaxle cover bolts and tighten.
- Install the gearshift lever cover using the gearshift lever cover bolts and tighten to 22 N·m (16 lb ft).
- Install the transaxle into the vehicle. Refer to Transmission Replacement.
Caution: Refer to Fastener Caution in the Preface section.
| • | the bigger transaxle cover bolts to 20 N·m (15 lb ft) |
| • | the smaller transaxle cover bolts to 15 N·m (11 lb ft) |
