Draining Procedure
Caution: Refer to Vehicle Lifting and Jacking Caution in the Preface section.
- Raise and support the vehicle
- Place a suitable fluid drainage container under the transaxle.
- Remove the fluid drain plug. Allow the fluid to drain completely.
- Clean the drain plug threads.
Caution: Refer to Fastener Caution in the Preface section.
- Install the fluid drain plug and tighten to
17 N·m (13 Ib ft).
Filling Procedure
- Remove the drainage container and lower the vehicle.
- Add 3/4 of the recommended amount of T-IV Automatic Transmission Fluid.
- Start the engine and allow it to reach normal operating temperature.
- Shift the gear selector through all positions.
Note: The correct fluid level must be between the HOT MIN (2) and the HOT MAX (1) notches on the dipstick.
- Check the fluid level and add fluid until the dipstick indicates a safe level.