1. Turn the ignition ON.
2. Turn the wiper switch to LO.
3. Measure the voltage at the wiper motor connector terminal 6.

Is the voltage within the specified range?

11-14 V

Go to Step 2

Go to Step 3

Replace the wiper motor.

Did you complete the replacement?

--

System OK

--

1. Disconnect the wiper switch.
2. Turn the wiper switch to LO.
3. Use an ohmmeter to check for continuity between the wiper switch connector terminal A8 and A5.

Does the ohmmeter indicate the specified value?

0 ohms

Go to Step 5

Go to Step 4

Replace the wiper switch.

Did you complete the replacement?

--

System OK

--

Repair the open circuit between the wiper switch connector terminal A5 and the wiper motor connector terminal 5.

Did you complete the repair?

--

System OK

--