Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the input shaft speed (ISS) sensor electrical connector.
- Remove the ISS sensor retaining bolt.
- Remove the ISS sensor from the transaxle.
Installation Procedure
Important: Lubricate the O-ring with ISU DEXRON III.
- Install a new O-ring on the ISS sensor.
Notice: Refer to Fastener Notice in the Preface section.
- Install the ISS sensor and retaining bolt into the transaxle case.
Tighten
Tighten the ISS sensor retaining bolt to 5.4 N·m (48 lb in).
- Connect the ISS sensor electrical connector.
- Connect the negative battery cable.