Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P0630: VIN Not Programmed or Mismatched - Engine Control Module (ECM)Circuit/System Description
This DTC sets when the engine control module (ECM) has determined that the vehicle identification number (VIN) is not stored in the ECM memory. When the control module is replaced, the VIN must be programmed into the control module memory.
Conditions for Running the DTC
| • | The control module is ON or awake. |
| • | The DTC runs continuously when the above condition is met |
Conditions for Setting the DTC
The ECM detects that no vehicle identification number (VIN) is stored in memory.
Action Taken When the DTC Sets
DTC P0630 is a type A DTC.
Conditions for Clearing the DTC
DTC P0630 is a type A DTC.
Diagnostic Aids
Some diagnostics will not run when the MIL is illuminated and DTC P0630 is set. Always program the VIN to the control module immediately after replacement.
If there are difficulties programming the VIN, ensure that all connections to the ECM and equipment are correct. Ensure that the latest software is installed and all programming procedures are performed correctly.
Reference Information
Description and Operation
Engine Control Module Description
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Circuit/System Verification
- Ignition ON, observe the Vehicle Information under I/M System Information on the scan tool. The VIN information should match the vehicles VIN.
- If the vehicle passes the Circuit/System Verification Test, then operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data List.
Important: The ECM cannot determine if the VIN programmed into the control module is valid. Always verify that the VIN displayed on the scan tool is correct for that vehicle.
| ⇒ | If a VIN is not displayed, program the VIN with a scan tool. |
| ⇒ | If a VIN is displayed, clear the DTCs with a scan tool. If DTC P0630 sets after clearing the DTCs, replace the ECM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for engine control module replacement, setup, and programming
