For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Remove the upper and the lower steering column cover and panel by removing the screws.
- Disconnect the electrical connector for the immobilizer detection coil.
- With the key in the ignition turned to the position designated ACC, remove the lock cylinder by pressing down the detent spring and pulling the lock cylinder out of the switch cylinder housing.
Warning: Refer to Battery Disconnect Warning in the Preface section.
Installation Procedure
- Install the lock cylinder.
- Connect the electrical connector for the immobilizer detection unit.
- Install the upper and the lower steering column cover panel with the screws and tighten to 2.5 N·m (22 lb in).
- Connect the negative battery cable.
Caution: Refer to Fastener Caution in the Preface section.
