Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Disconnect the electronic ignition (EI) system ignition coil connector.
- Note the ignition wire location and remove the ignition wires.
- Remove the EI system ignition coil retaining bolts.
- Remove the EI system ignition coil.
Installation Procedure
Caution: Refer to Fastener Caution in the Preface section.
- Install the EI system ignition coil into the mounting location and install the retaining bolts.
Tighten
Tighten the EI system ignition coil retaining bolts to 10 N·m (89 lb in).
- Connect the EI system ignition coil connector.
- Install the ignition wires.
- Connect the negative battery cable.