GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Optra - Mexico 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Replacement

Removal Procedure
  1. Raise and support the vehicle on an alignment rack. Refer to Lifting and Jacking the Vehicle.
  2. Remove the left and the right stabilizer shaft-to-stabilizer link nuts.

    3. Object Number: 1290741 Size: SH
  3. Remove the stabilizer shaft insulator clamp bolts.
  4. Remove the stabilizer shaft insulator clamps.
  5. Remove the stabilizer shaft insulators.
  6. Remove the stabilizer shaft from the vehicle.

Installation Procedure

    Note: There must be no grease or dirt on the stabilizer shaft. Verify the stabilizer shaft is clean.

  1. Install the insulators to the stabilizer shaft.
  2. Install the insulator clamps to the insulators.

    3. Object Number: 1290741 Size: SH
  3. Install the stabilizer shaft to the vehicle.

    4. Note: Do not tighten the bolts yet.

  4. Install the stabilizer shaft insulator clamp bolts.

    5. Notet: Do not tighten the nuts yet.

  5. Install the left and the right stabilizer shaft-to-stabilizer link nuts.
  6. Lower the vehicle onto the alignment rack in order to place the weight of the vehicle on the tires.

    7. Caution: Refer to Fastener Caution in the Preface section.

  7. Install the left and the right stabilizer shaft-to-stabilizer link nuts and tighten to 47 N·m (35 lb ft).
  8. Install the stabilizer shaft insulator clamp bolts and tighten to 40 N·m (30 lb ft).
  9. Lower the vehicle.