GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Optra - Mexico 🢒 Suspension 🢒 Rear Suspension 🢒 Strut Assembly Replacement

Removal Procedure

    Object Number: 1290675 Size: SH
  1. Remove the trunk carpeting that covers the rear strut mounting nuts. For station wagons, remove the panels that cover the luggage compartment wheelhouse trim panel, wagon. Refer to Cargo Area Rear Trim Panel Replacement.

    2. Object Number: 1290684 Size: SH
  2. Remove the rear strut mounting nuts.

    3. Object Number: 1290685 Size: SH
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
  4. Remove the wheel. Refer to Tire and Wheel Removal and Installation.
  5. Disconnect the parking brake. Refer to Park Brake Cable Replacement.

    6. Note: On vehicles equipped with rear drum brakes, the brake hose will easily disconnect from the strut assembly as the assembly is being removed from the vehicle. On vehicles equipped with rear disc brakes, the brake hose can be disconnected from the strut assembly at any time.

  6. Remove the clip that holds the brake hose to the strut assembly.

    7. Object Number: 1290707 Size: SH
  7. Remove the stabilizer link-to-strut assembly nut and disconnect the stabilizer link from the strut assembly.

    8. Object Number: 1290720 Size: SH
  8. Remove the knuckle-to-strut assembly nuts and the bolts.
  9. On vehicles equipped with rear drum brakes, lower the strut assembly and separate the brake line from the strut assembly.

    10. Object Number: 1290730 Size: SH
  10. Remove the rear strut assembly from the vehicle.

Installation Procedure

    Object Number: 1290731 Size: SH

    Note: On vehicles equipped with rear drum brakes, the brake hose will easily connect to the strut assembly as the assembly is being installed into the vehicle. On vehicles equipped with rear disc brakes, the brake hose can be connected to the strut assembly at any time after the strut assembly has been installed into the vehicle.

  1. Install the rear strut assembly into the vehicle. On vehicles equipped with rear drum brakes, secure the brake line into the holder as the assembly goes into place.
  2. Secure the strut assembly by loosely attaching the strut mount-to-body nuts.
  3. Install the knuckle-to-strut assembly nuts and bolts. Do not tighten.

    4. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1290685 Size: SH
  4. Install the clip holding the brake hose to the strut assembly with the knuckle-to-strut assembly nuts and tighten to 100 N·m (74 lb ft).

    5. Object Number: 1290707 Size: SH
  5. Connect the stabilizer link to the strut assembly and install the stabilizer link-to-strut assembly nut and tighten to 47 N·m (35 lb ft).

    6. Object Number: 1290684 Size: SH
  6. Connect the parking brake. Refer to Park Brake Cable Replacement.
  7. Install the wheel. Refer to Tire and Wheel Removal and Installation.
  8. Lower the vehicle.
  9. Install the strut mount-to-body nuts and tighten to 30 N·m (22 lb ft).

    10. Object Number: 1290675 Size: SH
  10. Install the trunk carpeting over the rear strut mounting nuts. For station wagons, remove the panels that cover the luggage compartment wheelhouse trim panel, wagon. Refer to Cargo Area Rear Trim Panel Replacement.