GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Optra - Mexico 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure
  1. Raise and support the vehicle on an alignment rack. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 1290741 Size: SH
  2. Remove the stabilizer shaft insulator clamp bolts.
  3. Remove the stabilizer shaft insulator clamp.
  4. Remove the stabilizer shaft insulator.
  5. Clean the stabilizer shaft.

Installation Procedure

    Note: There must be no grease or dirt on the stabilizer shaft. Verify the stabilizer shaft is clean.

  1. Install the stabilizer shaft insulator to the stabilizer shaft.

    2. Object Number: 1290741 Size: SH
  2. Install the stabilizer shaft insulator clamp to the insulator.

    3. Note: Do not tighten the bolts yet.

  3. Install the stabilizer shaft insulator clamp bolts.
  4. Lower the vehicle onto the alignment rack in order to place the weight of the vehicle on the tires.

    5. Caution: Refer to Fastener Caution in the Preface section.

  5. Install the stabilizer shaft insulator clamp bolts and tighten to 40 N·m (30 lb ft).
  6. Lower the vehicle.