For 1990-2009 cars only
- Perform a preliminary inspection before any attempt is made to change or correct the wheel alignment factors. Refer to Preliminary Alignment Inspection.
- Loosen the front parallel link cam bolt to crossmember.
- Rotate the parallel link adjustment bolts until the preferred rear toe specification is obtained, then tighten to 40 N·m (30 lb ft). Refer to Wheel Alignment Specifications.
- Hold the parallel link adjustment bolts, install the parallel link-to-crossmember nuts and tighten to 90 N·m (66 lb ft).
Caution: Refer to Fastener Caution in the Preface section.
