For 1990-2009 cars only
- Fill the power steering fluid reservoir to the MIN mark.
- Raise the vehicle until the front wheels are off the ground. Refer to Lifting and Jacking the Vehicle.
- Turn the ignition switch to the ON position with the engine OFF.
- Rotate the steering wheel from full left to full right 10 to 12 times.
- Verify the power steering fluid level is at or above the MIN mark.
- Start the engine.
- Listen for power steering pump noise like whining or cavitation. Inspect the fluid for aeration. If necessary, refer to Power Steering Fluid Leaks.
- Verify the fluid level is correct. Repeat the bleeding procedure if necessary.
- Turn the engine off.
- Lower the vehicle.
Caution: Refer to Air in the Power Steering System Caution in the Preface section.
Caution: Refer to Using Proper Power Steering Fluid Caution in the Preface section.
Note:
• Use clean, new power steering fluid only. Refer to
Fluid and Lubricant Recommendations. • Hoses touching the frame, body, or engine may cause system noise. Verify the hoses do not touch any other part of the vehicle. • Loose connections may not leak, but could allow air into the steering system. Verify that all hose connections are tight. • Power steering fluid level must be maintained throughout the bleeding procedure.
