When the ignition switch is turned to ON, the sensing and diagnostic module (SDM) will perform turn-on test to diagnose critical malfunctions within SDM itself.
Upon passing these test ignition and deployment loop voltages are measured to ensure that they are within their normal voltage ranges. The SDM monitors the voltages at the driver low and the passenger low to detect shorts to ground or voltage in the deployment loops.
This diagnostic procedure supports the following DTC:
DTC B1403 Passenger SIS Malfunction
Ignition voltage is within the normal operating voltage range.
The passenger side impact sensor is inoperative.
The SDM commands the AIR BAG indicator ON.
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Step | Action | Values | Yes | No |
---|---|---|---|---|
Warning: Refer to Sensing and Diagnostic Module Voltage after Ignition is Turned Off Warning in the Preface section. Warning: Refer to Sensing and Diagnostic Module Handling Warning in the Preface section. Schematic Reference: SIR Schematics Connector End View Reference: Component Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 | Visually inspect the connector and the wiring of the driver side air bag. Is the wiring damaged? | -- | Go to Step 4 | Go to Step 3 |
3 |
Is the resistance equal to the specified value? | 0 Ω | Go to Step 5 | Go to Step 4 |
4 | Replace the air bag wiring. Is the replacement complete? | -- | Go to Step 6 | -- |
5 | Replace the driver side impact module. Is the replacement complete? | -- | Go to Step 6 | -- |
6 |
Does the DTC reset? | -- | Go to Step 2 | System OK |