GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Prizm 🢒 Engine 🢒 Engine Mechanical - 1.8L 🢒 Intake Camshaft and Valve Lifter Replacement

Removal Procedure
  1. Remove the timing chain from the engine. Refer to Timing Chain and Sprocket Replacement in Engine Mechanical.

    2. Object Number: 237147 Size: SH
  2. Remove the intake camshaft sprocket bolt (1).

    3. Object Number: 426994 Size: SH
  3. Remove the cam sprocket (1).

    4. Object Number: 427001 Size: SH
  4. Remove the intake camshaft bearing cap bolts in sequence. Starting at the ends and working toward the center of the camshaft.
  5. Remove the front camshaft bearing cap (5).
  6. Remove the intake camshaft from the cylinder head.
  7. Remove and inspect the lifters for wear, replace as necessary.

Installation Procedure

    Object Number: 235547 Size: SH
  1. Install the intake camshaft onto the cylinder head with the number 1 cam lobes facing as shown.

    2. Important: Each bearing cap has a number and a directional arrow marked on the bearing cap.

  2. Install the camshaft bearing caps in their proper locations and direction.

    3. Object Number: 427001 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the camshaft bearing cap bolts.

    4. Tighten

        • Tighten the camshaft bearing cap bolts in the sequence shown to 13 N·m (10 lb ft).
        • Tighten the front bearing cap bolts to 23 N·m (17 lb ft).

    Object Number: 426994 Size: SH
  4. Install the intake camshaft sprocket (1) to the camshaft.

    5. Object Number: 237147 Size: SH
  5. Install the camshaft sprocket bolt (1) in order to secure the cam sprocket.

    6. Tighten
    Tighten the camshaft sprocket bolt to 44 N·m (33 lb ft).

  6. Install the timing chain onto the engine. Refer to Timing Chain and Sprocket Replacement in Engine Mechanical.
  7. Check and adjust valve clearance. Refer to Valve Lash Adjustment in Engine Mechanical.