GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1998 🢒 Prizm 🢒 Steering 🢒 Power Steering System 🢒 Power Steering System Bleeding

Bleed Procedure

Tools Required

    • J 35555 Mity Vac
    • J 43485 Power Steering Bleeder Adapter
   • 

Notice: If the power steering system has been serviced, an accurate fluid level reading cannot be obtained unless air is bled from the steering system. The air in the fluid may cause pump cavitation noise and may cause pump damage over a period of time.

Important: Hoses touching the frame, body, or engine may cause system noise.

  • Verify that the hoses do not touch any other part of the vehicle.
    •    • 
    Object Number: 443641 Size: SH

    Important: Loose connections may not leak, but may allow air into the steering system.

  • Verify that all of the hose connections are tight.

      • Object Number: 244018 Size: SH
    1. Remove the reservoir cap.

      2. Notice: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks.

      Important: Maintain the fluid level throughout the bleeding procedure.

    2. Inspect the fluid level (1,2). Add fluid, if necessary. Refer to Checking and Adding Power Steering Fluid .

      3. Object Number: 443646 Size: SH
    3. Attach the J 43485 to the J 35555 .
    4. Place the J 43485 on the reservoir filler neck.
    5. Apply a vacuum of 68 kPa (20 in Hg) maximum.
    6. Wait 5 minutes.

      7. Typical vacuum drop is 7-10 kPa (2-3 in Hg). If the vacuum does not remain steady, refer to the following procedures:

      •  Power Steering Gear Diagnosis
      •  Power Steering Pump Diagnosis
      •  Power Steering Gear and Pump Leaks
    7. Remove the J 43485 and the J 35555 .

      8. Object Number: 244018 Size: SH
    8. Reinstall the pump reservoir cap.
    9. START the engine. Allow the engine to idle.
    10. Turn OFF the engine.
    11. Inspect the fluid level (1,2). Add fluid, if necessary. Refer to Checking and Adding Power Steering Fluid .

      12. Object Number: 443653 Size: SH
    12. START the engine. Allow the engine to idle.
    13. Partially raise and support the vehicle in order to allow the front tires and wheels to turn freely. Refer to Lifting and Jacking the Vehicle in General Information.
    14. Ensure the front tires and wheels are in the straight ahead position.

      15. Important: Do not turn the steering wheel to lock.

    15. Turn the steering wheel 360 degrees in both directions 5 times.
    16. Turn the ignition switch OFF.

      17. Object Number: 244018 Size: SH
    17. Remove the reservoir cap.
    18. Inspect the fluid level (1,2). Add fluid, if necessary. Refer to Checking and Adding Power Steering Fluid

      19. Object Number: 443646 Size: SH
    19. Attach the J 43485 to the J 35555 .
    20. Place the J 43485 on the reservoir filler neck.
    21. Apply a vacuum of 68 kPa (20 in Hg) maximum.
    22. Wait 5 minutes.
    23. Remove the J 43485 and the J 35555 .

      24. Object Number: 244018 Size: SH
    24. Inspect the fluid level (1,2). Add fluid, if necessary. Refer to Checking and Adding Power Steering Fluid
    25. Install the reservoir cap.
    26. Lower the vehicle.