Notice: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.

1. Remove the throttle body. Refer to Throttle Body Assembly Replacement .
2. Remove the 2 fasteners (3) from the throttle position (TP) sensor (2).
3. Remove the TP sensor (2) from the throttle body.

1. Install the TP sensor (2) to the throttle body.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Secure the TP sensor with the 2 hold down fasteners (3).

Tighten
Tighten the fasteners to 3.5 N·m (30 lb in).

3. Install the throttle body to the intake manifold. Refer to Throttle Body Assembly Replacement .