Removal Procedure
- Disconnect the negative battery cable.
- Use a wrench and rotate the belt tensioner clockwise.
- With pressure applied to the wrench, and tension relieved from the drive belt, remove the accessory drive belt.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the right side lower engine splash shield.
- Properly route and install the accessory drive belt onto the drive pulleys.
- Use a wrench and rotate the belt tensioner clockwise.
- With pressure applied to the wrench, install the accessory drive belt.
- With the accessory drive belt installed properly, release the belt tensioner.
- Install the right side lower engine splash shield.
- Connect the negative battery cable.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the battery cable bolt to 15 N·m (11 lb ft).
