GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Prizm 🢒 Engine 🢒 Engine Mechanical - 1.8L 🢒 Intake Camshaft and Valve Lifter Replacement

Removal Procedure

    Important: When performing any service procedure that pertains to the camshaft or the camshaft actuator, unlock the camshaft actuator locking pin. Refer to Camshaft Actuator Locking Pin Adjustment .

  1. Remove the timing chain from the engine. Refer to Timing Chain and Sprocket Replacement .

    2. Object Number: 625497 Size: SH
  2. Remove the center bolt from the camshaft position actuator on the intake camshaft.

    3. Object Number: 625493 Size: SH
  3. Remove the camshaft position actuator from the camshaft.

    4. Object Number: 427001 Size: SH
  4. Remove the intake camshaft bearing cap bolts in sequence. Starting at the ends and working toward the center of the camshaft.
  5. Remove the front camshaft bearing cap (5).
  6. Remove the intake camshaft from the cylinder head.
  7. Remove and inspect the lifters for wear, replace as necessary.

Installation Procedure

    Object Number: 235547 Size: SH
  1. Install the intake camshaft onto the cylinder head with the number 1 cam lobes facing as shown.

    2. Important: Each bearing cap has a number and a directional arrow marked on the bearing cap.

  2. Install the camshaft bearing caps in their proper locations and direction.

    3. Object Number: 427001 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the camshaft bearing cap bolts.

    4. Tighten

        • Tighten the camshaft bearing cap bolts in the sequence shown to 13 N·m (10 lb ft).
        • Tighten the front bearing cap bolts to 23 N·m (17 lb ft).

    Object Number: 625493 Size: SH
  4. Install the camshaft position actuator to the camshaft.
  5. Install the timing chain onto the engine. Refer to Timing Chain and Sprocket Replacement .
  6. Unlock the camshaft actuator locking pin. Refer to Camshaft Actuator Locking Pin Adjustment .
  7. Check and adjust valve clearance. Refer to Valve Lash Adjustment .