Circuit Description
The valve relay is part of the Electronic Brake Control Module (EBCM). The EBCM turns ON the valve relay when the ignition switch is in the ON position and no malfunction exists in the ABS. The valve relay provides power to the ABS solenoid valves.
Conditions for Running the DTC
DTC C0125 can be set any time the ignition switch is in the ON position.
Conditions for Setting the DTC
The EBCM detects an open in the valve relay circuitry.
Action Taken When the DTC Sets
| • | The ABS is disabled. |
| • | The ABS warning indicator turns ON. |
Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Diagnostic Aids
Thoroughly inspect the wiring and the connectors. An incomplete inspection of the wiring and the connectors may result in a misdiagnosis, causing a part replacement with the reappearance of the malfunction.
The following are possible causes of the malfunction:
| • | An open or high resistance in the Battery Positive Voltage circuit |
| • | An open or high resistance in the Motor Ground circuit |
| • | An internal EBCM malfunction |
If an intermittent malfunction exists, refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.
Test Description
The number below refers to the step number on the Diagnostic Table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Antilock Brake System Schematics | |||
1 | Did you perform A Diagnostic System Check - ABS? | Go to Step 2 | |
Does the DTC reset? | Go to Step 3 | Go to Diagnostic Aids | |
3 |
Did you find and correct the condition? | Go to Step 5 | Go to Step 4 |
4 | Replace the Brake Pressure Modulator Valve (BPMV). Refer to Brake Pressure Modulator Valve Assembly Replacement . Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
