GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1996 🢒 S10 Pickup - 2WD 🢒 Engine 🢒 Engine Controls - 2.2L 🢒 Throttle Position Sensor Replacement

Removal Procedure

    Object Number: 2291 Size: SH
  1. Remove the electrical connector.

    2. Object Number: 9837 Size: SH
  2. Remove the TP sensor attaching screws and retainers.

    3. Notice: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.

  3. Remove the TP sensor from the throttle body assembly.

Installation Procedure

    Object Number: 9837 Size: SH
  1. With the throttle valve closed, install the TP sensor on the throttle shaft.

    2. Rotate counterclockwise in order to align the mounting holes.

  2. Install the TP sensor attaching screws and retainers.

    3. Tighten
    Tighten the retainers and screws to 2-4 N·m (18-35 lb in).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 2291 Size: SH
  3. Install the electrical connector.