GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1996 🢒 S10 Pickup - 2WD 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 4L60-E 🢒 Control and Shift Solenoids Replacement

Removal Procedure
  1. Remove the oil pan and the gasket. Refer to Oil Pan Replacement

    2. Object Number: 14464 Size: SH
  2. Remove the accumulator cover bolts.
  3. Remove the 1-2 accumulator cover

    4. Object Number: 14467 Size: SH
  4. Remove the 1-2 accumulator piston.
  5. Remove the piston spring.

    6. Object Number: 7746 Size: SH
  6. Disconnect the component electrical connectors.

    7. Object Number: 13876 Size: SH
  7. Remove the pressure control solenoid retainer bolt.

    8. Object Number: 13880 Size: SH
  8. Remove the pressure control solenoid retainer and the pressure control solenoid.

    9. Object Number: 13884 Size: SH
  9. Remove the shift solenoid retainers.

    10. Object Number: 13364 Size: SH
  10. Remove the shift solenoids.

    11. Object Number: 13365 Size: SH
  11. Remove the 3-2 control solenoid retainer.

    12. Object Number: 13886 Size: SH
  12. Remove the 3-2 control solenoid.

Installation Procedure

    Object Number: 13886 Size: SH
  1. Install the 3-2 control solenoid.

    2. Object Number: 13365 Size: SH
  2. Install the 3-2 control solenoid retainer.

    3. Object Number: 13364 Size: SH
  3. Install the shift solenoids.

    4. Object Number: 13884 Size: SH
  4. Install the shift solenoid retainers.

    5. Object Number: 13883 Size: SH
  5. Install the pressure control solenoid. Ensure that the electrical tabs are facing outboard.

    6. Object Number: 13880 Size: SH
  6. Install the pressure control solenoid retainer.

    7. Object Number: 13876 Size: SH
  7. Install the pressure control solenoid retainer bolt.

    8. Object Number: 7746 Size: SH
  8. Install the component electrical connectors.

    9. Object Number: 14467 Size: SH
  9. Install the 1-2 accumulator piston to the accumulator cover. Ensure that the piston legs face toward the case.
  10. Install the 1-2 accumulator spring onto the piston.

    11. Object Number: 14464 Size: SH
  11. Install the 1-2 accumulator cover and the bolts.

    12. Tighten
    Tighten the bolts to 11 N·m (97 lb in.).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  12. Install the oil pan and the gasket. Refer to Oil Pan Replacement