Power Steering Fluid Reservoir Replacement - Off Vehicle CB Series

1. Remove the power steering pump from the vehicle. Refer to Power Steering Pump Replacement .



2. Remove the pump retaining clips (2).
3. Remove the reservoir assembly (1) from the pump housing assembly.
4. Remove the O-ring seal from the pump housing assembly.

Discard the O-ring seal.

Important: Use new O-ring seal when assembling the power steering pump assembly.

1. Lubricate the O-ring seal using power steering fluid.
2. Install the O-ring seal to the pump housing assembly.



3. Install the reservoir assembly (1) to the pump housing assembly.
4. Install the pump retaining clips (2) to the pump housing assembly.
5. Install the power steering pump. Refer to Power Steering Pump Replacement .

Power Steering Fluid Reservoir Replacement - Off Vehicle P Series

1. Remove the power steering pump from the vehicle. Refer to Power Steering Pump Replacement .



2. Drain the power steering fluid from the power steering pump.
3. Remove the pump mounting studs (2).
4. Remove the connector and fitting assembly (4).
5. Remove the O-ring seal (3).



6. Remove the reservoir assembly (1) from the pump housing assembly (2).



7. Remove the O-ring seals (1,4,5).
8. Remove the magnet (3).
9. Clean the magnet (3).

Important: 

•	Do not remove the welch plug.

•	If the welch plug is deformed or dislodged, replace the power steering pump housing (2).

10. Inspect the welch plug in the power steering pump housing (2).

Important: Use new O-ring seals when assembling the power steering pump assembly.

1. Lubricate the O-ring seals (1,4,5) using power steering fluid.
2. Install the O-ring seals (1,4,5) to the pump housing assembly.
3. Install the magnet (3) to the pump housing assembly (2).



4. Connect the reservoir assembly (1) to the pump housing assembly (2).



5. Install the O-ring seal.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the connector and fitting assembly (4) to the pump housing (1).

Install the pump mounting studs (2) to the pump housing (1).

Tighten

•	Tighten the pump mounting studs (2) to 35-80 N·m (29-59 lb ft).

•	Tighten the connector and fitting assembly (4) to 75 N·m (55 lb ft).

7. Install the power steering pump to the vehicle. Refer to Power Steering Pump Replacement .