Assist Step Support Bracket Replacement Diamond Edition
Removal Procedure
- Remove the assist step
assembly.
- Remove the 3 mounting brackets.
2.1. | Remove 2 nuts from the U-bolt of each bracket. |
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 3 mounting
brackets if required.
1.1. | Install the U-bolt into the frame. |
1.2. | Install the bracket with 2 nuts. |
Tighten
Tighten the bracket nuts to 35 N·m (26 lb ft).
- Install the assist step assembly to the mounting brackets.