For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the evaporative emission (EVAP) chassis purge pipe from the engine purge pipe.
- Disconnect the EVAP chassis purge pipe (1) from the canister purge pipe.
- Remove the EVAP and fuel chassis bundle. Refer to Fuel Hose/Pipes Replacement - Chassis .
Installation Procedure
Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.- Install the EVAP and fuel chassis bundle. Refer to Fuel Hose/Pipes Replacement - Chassis .
- Connect the EVAP chassis purge pipe (1) to the canister purge pipe.
- Connect the EVAP chassis purge pipe to the engine purge pipe.
- Lower the vehicle.
