Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the On-Board Diagnostic (OBD) System Check performed? | -- | Go to OBD System Check | |
2 | Is the battery voltage greater than the specified value? | 12 V | ||
3 | Are there any other engine problems that could affect starting? | -- | Go to Engine Controls | |
4 | Temporarily move the ignition switch to the START position while measuring the voltage between the negative battery terminal and the engine block. Is the voltage reading less than the specified value? | 0.5 V | ||
5 | Temporarily move the ignition switch to the START position while measuring the voltage between the starter solenoid terminal B and the RED (32) wire (2.2L) or the RED (19) wire (4.3L) at the battery. Is the voltage reading more than the specified value? | 0.5 V | ||
6 | Replace the negative battery cable. Refer to Battery Cable . Is the replacement complete? | -- | System OK | -- |
7 | Repair the starter motor. Refer to Starter Motor Replacement . Is the repair complete? | -- | System OK | -- |
8 | Replace the positive battery cable. Refer to Battery Cable . Is the replacement complete? | -- | System OK | -- |
9 | Charge the battery. Refer to Battery Charging . Is the battery voltage greater than the specified value? | 12 V | System OK | -- |
