Circuit Description
The indicator lamps circuit consists of three individual lamps contained inside their respective buttons making up the transfer case shift control switch assembly. They are the 2HI, 4HI and 4LO indicators. When the ignition switch is placed in the RUN position, current is provided to the switch assembly. The transfer case shift control module provides a ground for the indicators when a particular gear is active or when the transfer case is in transition. Through solid state circuity located inside the switch assembly, voltage can be regulated to provide less illumination when the headlamps or parking lights are turned ON.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step helps to determine intermittent conditions.
-
This step helps to determine if the transfer case shift control module is commanding more than one indicator ON.
-
This step tests and repairs a short to ground in the indicator control circuits.
-
This step tests if more than one indicator control circuits are shorted together.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 |
Important: The transfer case shift control module is not a class 2 device, and therefore a scan tool can not be utilized on this transfer case. Did you perform A Diagnostic System Check - Transfer Case? | -- | Go to Step 2 | Go to Diagnostic System Check |
Do two or more switch indicator lamps still remain ON? | -- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | |
Do all the switch indicator lamps stay OFF? | -- | Go to Step 5 | Go to Step 4 | |
Repair a short to ground on the suspect indicator control circuit(s) (the one(s) that remain ON). Refer to General Electrical Diagnosis and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 6 | |
Test the suspect indicator control circuit(s) to determine if they are shorted together. Refer to General Electrical Diagnosis and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 7 | |
6 | Replace the shift control switch. Refer to S4WD Select Switch Replacement in Instrument Panel, Gauges, and Console. Did you complete the replacement? | -- | Go to Step 8 | -- |
7 | Replace the transfer case shift control module. Refer to Transfer Case Shift Control Module Replacement . Did you complete the replacement? | -- | Go to Step 8 | -- |
8 | Operate the vehicle within the conditions for causing the symptom as specified in the supporting text. Does the symptom re-occur? | -- | Go to Step 2 | System OK |
