GM Service Manual Online
For 1990-2009 cars only

Vehicle Speed Sensor NV3500

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

  2. Object Number: 102878  Size: SH
  3. Disconnect the electrical connector from the vehicle speed sensor assembly.
  4. Place a drain pan under the transmission in order to catch the oil.

  5. Object Number: 4779  Size: SH
  6. Remove the following parts:
  7. • The bolt
    • The vehicle speed sensor
    • The O-ring seal

Installation Procedure

  1. Coat a new O-ring seal with a thin film of transmission oil. Use Synchromesh Transmission Fluid or the equivalent.

  2. Object Number: 4779  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the following parts:
  4. • The O-ring on the vehicle speed sensor assembly
    • The vehicle speed sensor assembly
    • The bolt

    Tighten
    Tighten the bolt to 22 N·m (16 lb ft).


    Object Number: 102878  Size: SH
  5. Install the electrical connector on the vehicle speed sensor assembly.
  6. Lower the vehicle.