Driver Information Center Replacement Non-Sunroof

1. Remove the screw at the front of the console that retains the console to the roof.
2. Pull downward at the rear of the console in order to remove the console from the roof.
3. Disconnect the electrical connections as needed.

1. Connect the electrical connections as needed.



2. Insert the mounting tabs into the roof panel and push upward on the rear of the console in order to install the console to the roof.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the screw at the front of the console that retains the console to the roof.

Tighten
Tighten the screw to 1.9 N·m (17 lb in).

Driver Information Center Replacement Sunroof Equipped

1. Remove the screw at the front of the console that retains the sunroof console to the roof.
2. Pull downward on the rear of the console in order to expose the electrical connections (1,4,5 and 6) and remove the sunroof console from the roof.



3. Disconnect the electrical connectors (1,4,5 and 6) as needed.
4. Remove the screw that retains the sunroof console mounting bracket to the roof.
5. Release the tabs at the rear of the bracket in order to remove the sunroof console mounting bracket from the roof.

Important: Ensure that the Flux Gate wire (4) is not trapped between the retainer and the roof steel.

1. Install the sunroof console bracket to the roof.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screw that retains the sunroof console mounting bracket to the roof.

Tighten
Tighten the screw to 1.9 N·m (17 lb ft).




3. Install the electrical connectors (1,4,5 and 6) as needed.
4. Insert the console mounting tabs into the mounting bracket and push upward on the rear of the console in order to install the console.
5. Install the screw at the front of the console that retains the console to the roof.

Tighten
Tighten the screw to 1.9 N·m (17 lb in).