Name | Location | Locator View | Connector End View |
|---|---|---|---|
Body Relay Block | To the left of the dash, to the right of the IP Fuse Block | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Body Control Module (BCM) Connector C1, (24 Cavities) | At the lower rear of the IP, on the heater | Body Control System Component Views in Body Control System | Body Control System Connector End Views in Body Control System |
Remote Control Door Lock Receiver | On the left IP sound insulator | ||
Underhood Fuse Block | On the top of the left inner wheelwell | Power and Grounding Component Views in Wiring Systems | -- |
Underhood Fuse Block Connector C1 (68 Cavities) (4-door Utility Body harness) | In the underhood fuse block | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
Underhood Fuse Block Connector C2 (68 Cavities) | Below the underhood fuse block | Power and Grounding Component Views in Wiring Systems | Power and Grounding Connector End Views in Wiring Systems |
G103 (2.2 L Engine) | (CKT 351) At the engine harness, to the right front of the engine block, under the generator | Harness Routing Views in Wiring Systems | -- |
G103 (4.3 L Engine) | (CKT 351) At the engine harness, to the right rear of the cylinder head | Harness Routing Views in Wiring Systems | -- |
G105 (2.2 L Engine) | (CKT 450, CKT 451) At the engine harness, to the right rear of the engine block, near the Ignition control module | Harness Routing Views in Wiring Systems | -- |
G105 (4.3 L Engine) | (CKT 450, CKT 451) At the engine harness, to the left rear of the cylinder head | Harness Routing Views in Wiring Systems | -- |
G200 | (CKT 1850) At the body harness, to the left front of the IP, above P100 | Harness Routing Views in Wiring Systems | -- |
P100 | At the IP bulkhead pass-through, to the left rear of the engine compartment, on the cowl | Harness Routing Views in Wiring Systems | -- |
S106 (2.2 L Engine) | (CKT 351) At the engine harness, between the breakouts to the PCM and to the fuel injector connector, 25 cm (9.8 in) from the breakouts to the PCM | Harness Routing Views in Wiring Systems | -- |
S106 (4.3 L Engine) | (CKT 351) At the engine harness, between the breakouts to the rear heated oxygen sensors connector and the body harness connector, 7 cm (2.75 in) from the breakout to the heated oxygen sensor connector | Harness Routing Views in Wiring Systems | -- |
S152 (2.2 L Engine) | (CKT 351, CKT 413, CKT 451) At the engine harness, between the breakouts for the left rear and the right rear engine block grounds, 15 cm (5.9 in) from the breakout to the left rear engine grounds | Harness Routing Views in Wiring Systems | -- |
Splice Pack SP202 | (CKT 379, CKT 1850) Strapped to the body harness, at the left center of the IP | -- | -- |
