The Transmission Scan Tool Data List contains manual transmission related parameters that are available on the scan tool. The list is arranged in alphabetical order. The parameters in the Typical Scan Data values column represent values that would be seen on a normally running engine.
A complete list of all engine related scan tool parameters can be found in the Scan Tool Data List in Engine Controls.
Important:: A scan tool that displays faulty data should not be used, and the condition should be reported to the scan tool manufacturer. Use of a faulty scan tool can result in misdiagnosis and unnecessary parts replacement.
Only the parameters listed below are referred to in this service manual for use in diagnosis. For further information on using the scan tool to diagnose the PCM and related sensors, refer to the applicable reference section listed below. If all values are within the typical range described below, refer to Symptoms - Engine Controls in Engine Controls section for diagnosis. The Typical Scan Data Values table contains all the parameters included in the following data lists arranged in alphabetical order:
Engine Data 1: Contains general information regarding fuel delivery and basic engine operating conditions.Engine Data 2: Contains general information regarding CKP, CMP, KS, A/C, and basic engine operating conditions.
Engine Data 3: Contains general information regarding fuel delivery, ECT, IAT, VTD, and basic engine operating conditions.
EVAP Data: Contains information specific to the evaporative emissions (EVAP) control system. Also displays parameters required to verify proper EVAP system operation.
Fuel Trim Data: Contains specific information regarding fuel trim.
Misfire Data: Contains specific information regarding misfire diagnostics and parameters required to verify proper operation with regard to misfire.
For a complete list of scan tool parameter definitions, refer to Scan Tool Data List in Engine Controls.
Important: Use the Typical Scan Data Values only after the following conditions are met:
| • | The Diagnostic System Check-Engine Controls has been completed. |
| • | The engine is idling, unless checking a value at a specified RPM. |
| • | The throttle is closed, unless checking a value at a specified RPM. |
| • | The vehicle is in PARK or NEUTRAL. |
| • | The vehicle is operating in Closed Loop. |
| • | The vehicle accessories are turned OFF. |
Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
Vehicle Speed Sensor | Engine 1 Engine 2 Engine 3 EVAP Fuel Trim Misfire | km/h mph | 0 |
