Tools Required
J 24433
Press Tube
Important:
• | Lubricate all components with transmission fluid before installation. |
• | The machined surface faces the needle thrust bearing. |
- Install the 5th gear using
J 24433
and a hydraulic press.
- Install the thrust bearing (2).
- Install the two caged needle bearings (1).
- Install the 3rd gear (5).
- Install the wavy washer (4).
- Install the 3rd gear blocking ring (3).
- Install the thrust bearing (2).
Important: Use a NEW thrust washer.
- Install a new thrust washer (1).
Important:
• | The machined surface of the synchronizer faces the thrust washer. |
• | Make sure to align the slots in the synchronizer with the gear blocking ring tabs. |
- Install the 3rd/4th synchronizer using the
J 24433
and a hydraulic press.
Important: Make sure the oil hole on the bearing collar is 90 degrees from the oil hole in the shaft.
- Install the bearing collar using an appropriate tool and a hydraulic press.
- Install the 4th gear blocking ring (6).
- Install the caged needle bearing (4).
Important: To properly install the wavy washer, tabs must snap into 4th gear.
- Assemble wavy washer (5) to the 4th gear (3) and install.
Important: The pocketed side of the thrust bearing (2) faces the thrust washer.
- Install the thrust bearing (2).
- Install the thrust washer (1).