Tools Required

J-42759 Ignition Switch Connector Release Tool

Caution: Refer to SIR Caution in the Preface section.




1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
2. Remove the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
3. Rotate the key alarm connector (1) 90 degrees.
4. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).



5. Disconnect the connector from the ignition switch assembly.
6. Remove the wires encased in the ignition switch clip, which is located on the side of the ignition switch.
7. Remove the ignition switch assembly (2) using J-42759 .

1. Insert J-42759 into the ignition lock cylinder case assembly (1) and slide the ignition switch assembly (2) in.
2. Connect the connector to the ignition switch assembly (2).




Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

3. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
4. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
5. Install the wires back into the ignition switch clip.
6. Install the steering wheel theft deterrent lock. Refer to Steering Wheel Theft Deterrent Lock Replacement .
7. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.