For 1990-2009 cars only
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Make sure the vehicle is level.
- Inspect the rear axle for leaks. Repair as necessary.
- Clean the area around the rear axle fill plug.
- Remove the rear axle fill plug.
- Inspect the lubricant level.
- If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.
- Install the rear axle fill plug.
- Lower the vehicle.
Specification
The lubricant level should be between 0-10 mm (0-0.4 in)
below the fill plug opening.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the rear axle fill plug to 33 N·m (24 lb ft).
