The data link connector (DLC) allows a scan tool to communicate with the class 2 serial data line. The serial data line is the means by which the microprocessor-controlled modules in the vehicle communicate with each other. Once the scan tool is connected to the class 2 serial data line through the DLC, the scan tool can be used to monitor each module for diagnostic purposes and to check for diagnostic trouble codes (DTCs). Class 2 serial data is transmitted on a single wire at an average of 10.4 kbps. This value is an average, class 2 uses a variable pulse width modulation to carry data and depending on the message it may operate faster or slower. The bus will float at a nominal 7.0 volts during normal operation. Each module can pull this lower during the transmission. The bus is not at battery positive voltage or ground potential during normal operation. When the ignition switch is in RUN, each module communicating on the class 2 serial data line sends a state of health (SOH) message every 2 seconds to ensure that the module is operating properly. When a module stops communicating on the class 2 serial data line, for example if the module loses power or ground, the SOH message it normally sends on the data line every 2 seconds disappears. Other modules on the class 2 serial data line, which expect to receive that SOH message, detect its absence; those modules in turn set an internal DTC associated with the loss of SOH of the non-communicating module. The DTC is unique to the module which is not communicating, for example, when the inflatable restraint sensing and diagnostic module (SDM) SOH message disappears, several modules set DTC U1088. Note that a loss of serial data DTC does not normally represent a failure of the module that set it.

The class 2 serial data link allows the following modules to communicate with each other:

The class 2 serial data link also allows a scan tool to communicate with the above modules for diagnostic and testing purposes.

The class 2 serial data link on this vehicle is a ring/star configuration. The class 2 serial data circuits are bussed together via the DLC connector and SP201. Refer to Data Link Communications Component Views for the location of the DLC and SP201.

The data link connector (DLC) allows a scan tool to communicate with the class 2 modules. The DLC is a standardized 16 cavity connector located below the instrument panel and close to the steering column. Connector design and location is dictated by an industry wide standard, and it is required to provide the following:

Refer to Data Link Communications Connector End Views .

Each control module connected to the class 2 serial data circuit monitors serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. In addition, node alive messages are transmitted by each module on the class 2 serial data circuit about once every 2 seconds. If a module does not receive a node alive message when expected, a DTC will set. If a module detects that the class 2 serial data circuit is shorted, the setting of all other class 2 serial communication DTCs is inhibited, and DTC U1300, U1301, or U1305 will set.