Removal Procedure
- Apply protective tape to the front edge of the front door and the rear edge of the front bumper fascia.
- Remove the wheelhouse panel. Refer to Front Wheelhouse Liner Replacement .
- Remove the rocker panel molding. Refer to Rocker Panel Front Molding Replacement in Exterior Trim.
- Remove the front Fascia. Refer to Front Bumper Fascia Replacement in Bumpers.
- Remove the side hood bumper from the vehicle.
- Remove the bolts that retain the fender to the vehicle.
- Remove the fender from the vehicle.
Notice: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
Remove the assist step.
Installation Procedure
- Position the fender to the vehicle.
- Install the bolts that retain the fender to the vehicle.
- Install the hood bumper to the vehicle.
- Install the front fascia. Refer to Front Bumper Fascia Replacement in Bumpers.
- Install the rocker panel molding. Refer to Rocker Panel Front Molding Replacement in Exterior Trim.
- Install the wheelhouse panel. Refer to Front Wheelhouse Liner Replacement .
- Install the assist step.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
