GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 SSR 🢒 Body and Accessories 🢒 Doors 🢒 Diagnostic System Check - Door Systems

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

    2.

  2. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the following modules:
    3. • The roof door module (RDM)
    • The body control module (BCM)
    • The powertrain control module (PCM)
    • The instrument panel cluster (IPC)

Does the scan tool communicate with all of the modules?

Go to Step 4

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Important: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.

  1. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool.
  2. Rotate the ignition switch through all positions while observing the ignition switch power mode parameter.

Does the ignition switch parameter reading match the ignition switch position for all switch positions?

Go to Step 4

Go to Power Mode Mismatch in Body Control System

4

With the scan tool, select the Display DTCs function for each of the following modules:

    • The roof door module
    • The body control module
    • The powertrain control module
    • The instrument panel cluster

Does the scan tool display any DTCs?

Go to Step 5

Go to Symptoms - Doors

5

Does the scan tool display any DTCs which begin with a "U"?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Go to Step 6

6

Does the scan tool display B1000, B1009 orB1011 for any of the modules?

Go to Diagnostic Trouble Code (DTC) List in Body Control System

Go to Step 7

7

Does the scan tool display a B1517 in the roof door module?

Go to Diagnostic Trouble Code (DTC) List in Roof

Go to Diagnostic Trouble Code (DTC) List