Disconnect Procedure
- Record all preset and theft codes from the radio.
- Turn the ignition switch to the LOCK position.
- Verify that all the electrical components are off such as interior lights, the underhood lamp, etc.
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle in General Information.
- Remove the rear battery cover bolts (1) and cover (2).
- Disconnect negative battery cable.
Connect Procedure
- Verify that all electrical components are off such as interior lights, the underhood lamp, etc.
- Clean any corrosion from the negative battery cable using a wire brush.
Notice: Refer to Fastener Notice in the Preface section.
- Connect the negative battery cable.
Tighten
Tighten the cable bolt to 15 N·m (11 lb ft).
- Install the rear battery cover (2) and nuts (1).
Tighten
Tighten nuts to 10 N·m (89 lb in).
- Lower the vehicle.
- Reset the radio presets and theft codes.
- Perform the reinitialization of the power windows. Refer to
Power Window Reinitialization.