GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Raise Vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .

  3. Object Number: 1442897  Size: SH
  4. Disconnect the cooler lines from the bracket (2).
  5. Remove the transmission cooler line bracket (2).

  6. Object Number: 309713  Size: SH
  7. Remove the right transmission cover bolt.

  8. Object Number: 663527  Size: SH
  9. Remove the starter bolts.
  10. Slide the starter forward until the starter clears the transmission.

  11. Object Number: 662991  Size: SH
  12. Remove the starter solenoid nut (3).
  13. Remove the starter lead (2) from the solenoid stud.
  14. Remove starter from vehicle through right wheel well opening.

  15. Object Number: 663472  Size: SH
  16. If necessary, remove the starter shield.

Installation Procedure


    Object Number: 663472  Size: SH
  1. If necessary, install the starter shield.
  2. Install starter to vehicle through right wheel well opening.

  3. Object Number: 662991  Size: SH
  4. Install the starter solenoid lead (2) to the solenoid stud.
  5. Notice: Refer to Fastener Notice in the Preface section.

  6. Install the starter solenoid nut (3).
  7. Tighten
    Tighten the starter solenoid nut to 3.4 N·m (30 lb in).

  8. Install the starter power lead (1) and nut.
  9. Tighten
    Tighten the starter lead nut to 9 N·m (80 lb in).


    Object Number: 663527  Size: SH
  10. Slide the starter rearward.
  11. Install the starter bolts.
  12. Tighten
    Tighten the starter bolts to 50 N·m (37 lb ft).


    Object Number: 309713  Size: SH
  13. Install the right transmission cover bolt.
  14. Tighten
    Tighten the transmission cover bolt to 9 N·m (80 lb in).


    Object Number: 1442897  Size: SH
  15. Install the transmission cooler line bracket and bolt.
  16. Tighten
    Tighten the transmission cooler line bracket bolt to 12 N·m (106 lb in).

  17. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  18. Lower the vehicle.