Important: Clean all the fuel pipe connections and surrounding areas before disconnecting the pipes in order to avoid possible contamination of the fuel system.

1. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief .
2. Disconnect the fuel feed (1) from the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
3. Cap the fuel rail pipes.
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
5. Remove the fuel pipe bracket nut (2).
6. Remove the fuel pipe bracket from the bellhousing stud.



7. Remove the fuel lines from the retaining clips (1) on the transmission.



8. Disconnect the fuel feed line from the rear fuel feed line. Refer to Plastic Collar Quick Connect Fitting Service .
9. Disconnect the fuel line from the fuel filter. Refer to Plastic Collar Quick Connect Fitting Service .
10. Cap the rear fuel lines.
11. Remove the fuel line bundle.

Important: Note the position of the fuel bundle clips prior to disassembly.

12. Remove the fuel line bundle retaining clips.
13. Remove the fuel feed and/or evaporative emission (EVAP) pipe to be replaced.

1. Install the fuel feed and/or EVAP pipe that was to be replaced.
2. Install the fuel line bundle retaining clips.
3. Install the fuel line bundle.
4. Cap the rear fuel lines.
5. Connect the fuel line to the fuel filter. Refer to Plastic Collar Quick Connect Fitting Service .
6. Connect the fuel feed line to the rear fuel feed line. Refer to Plastic Collar Quick Connect Fitting Service .



7. Install the fuel lines to the retaining clips (1) on the transmission.



8. Install the fuel pipe bracket to the bellhousing stud.

Notice: Refer to Fastener Notice in the Preface section.

9. Install the fuel pipe bracket nut (2).

Tighten
Tighten the nut to 10 N·m (89 lb in).

10. Lower the vehicle.
11. Remove the caps from the fuel rail pipes.
12. Connect the fuel feed pipe (1) to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service .
13. Install the fuel fill cap.
14. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
15. Use the following procedure in order to inspect for leaks:

15.1.

Turn the ignition ON, with the engine OFF, for 2 seconds.

15.2.

Turn the ignition OFF for 10 seconds.

15.3.

Turn the ignition ON, with the engine OFF.

15.4.

Inspect for fuel leaks.