- Clean the automatic transmission flex plate in solvent.
- Dry the flex plate with compressed air.
- Inspect the flex plate for the following conditions:
• | Damaged ring gear teeth |
• | Stress cracks around the flex plate-to-crankshaft bolt hole locations |
| Important: Do not attempt to repair the welded areas that retain the ring gear to the flex plate. Install a new flex plate.
|
• | Welded areas that retain the ring gear onto the flex plate for cracking |
Important: In order to maintain the proper component balance, contact surface taper, and heat transfer, manual transmission flywheels are NOT to be machined.
- Clean the manual transmission flywheel in solvent.
- Dry the flywheel with compressed air.
- Inspect the flywheel for the following conditions:
• | Grooved or scored surface (2) |
• | Damaged ring gear teeth (4) |
• | Loose or improperly positioned ring gear. The ring gear has an interference fit onto the flywheel and should be positioned completely against the flange of the flywheel. |
• | Missing, bent, or damaged pressure plate locating pins. The 2 locating pins are installed into the flywheel and spaced 170 degrees apart to ensure proper orientation of the clutch pressure plate to the engine flywheel during assembly. |