GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Reposition bulk wiring harness connectors aside.
  2. Disconnect the throttle actuator control (TAC) module electrical connectors from the TAC module.
  3. Remove nuts retaining TAC module and remove module.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.

  1. Install TAC module and retaining nuts
  2. Tighten
    Tighten the nuts to 10 N·m (89 lb in).

  3. Connect TAC module electrical connectors.
  4. Position bulk wiring harness connectors back into place.
  5. Refer to Control Module References for programming and setup information.