Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module
(SDM). Before applying power to the SDM, make sure that it is securely fastened with
the arrow facing toward the front of the vehicle. Failure to observe the correct
installation procedure could cause SIR deployment, personal injury, or unnecessary
SIR system repairs.
Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the supplemental inflatable restraint (SIR) system. Refer to
SIR Disabling and Enabling .
- Remove the floor console. Refer to
Console Replacement.
- Remove the 3 fasteners to the sensing and diagnostic module (SDM).
- Remove the connection position assurance (CPA) (1) from the SDM.
- Rotate the locking arm (1) to release the electrical connector from the SDM.
- Disconnect the electrical connection from the SDM.
- Remove the SDM from the vehicle.
Installation Procedure
- Remove any dirt, grease, etc. from the mounting surface.
- Install the SDM to the vehicle.
- Connect the electrical connection to the SDM.
- Rotate the locking arm (1) to lock the electrical connector to the SDM.
- Install the CPA (1) to the SDM.
Notice: Refer to Fastener Notice in the Preface section.
- Install the nuts that retain the SDM to the floor panel.
Tighten
Tighten the nuts to 12 N·m (106 lb in).
- Install the floor console. Refer to
Console Replacement.
Important: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring that the SDM part number to be setup in multiple modules. If the indicator remains ON after enabling the SIR system,
perform the diagnostic system check and follow steps thoroughly to ensure that the SDM is setup properly.
- Enable the SIR system. Refer to
SIR Disabling and Enabling .
- Refer to
Control Module References for programming and setup information.